Liqua-Tech Corporation
3501 N. State St., Ukiah, California 95482
707-462-3555 · 800-659-3556 · 707-462-3576 (fax)

The VRA-Series Adapter and Calibration Plates were designed in response to a need for easily adapting Veeder-Root totalizing, reset printing and non-printing counter registers to Liqua-Tech flowmeters or Neptune flowmeters which normally use Neptune 400, 600 and 800 series counter registers. These adapter and calibration plates are designed to retrofit with the existing adapter tower which comes with the meter and yet provide an extremely low profile, one-piece unit when converting from a Neptune register to the Veeder-Root register. In addition, calibration is still accomplished utilizing the easy to replace and widely available Neptune style change gears.

Adapts to:
Veeder-Root Register Models 7890 & 7887
Adapts from:
Liqua-Tech LPM-100, LPM-101, LPM-200
Neptune 3/4", 1", 1-1/4", 1-1/2", 2", Type 4D, Type S, and 1", 2" MP

Calibration Gears: .770 Neptune Style Change Gears

Materials:
Plates: Nickel plated Aluminum
Shafting: Stainless Steel

Compact, low profile, lightweight

Uses Neptune style change gears

Uses four (4) bolt holddown versus two (2) register studs (Neptune)

Integral non-reverse clutch

Adapts all Neptune meters which use either 400, 600 or 800 series registers

For more specific details about our gearplate adapters,
check out our full line of Adapter and Calibration Plates

HOME | LPM-102 | LPM-100 | LPM-200 | LPM-101
VRA-SERIES | TRAC-BEARING CHAMBER | DISTRIBUTORS

Questions? Comments? E-mail us.

Copyright © 2000, Liqua-Tech Corp.